|
PowerPC |
|
MPC603/604 |
|
MPC603 or MPC604R PowerPC 6U VMEbus Processor Modules |
MVME2300 |
- 200 MHz MPC603 or 333 MHz MPC604R PowerPC processor
- VME64 bus extension
- 16MB, 32MB, 64MB, or 128MB ECC DRAM
- DMA for fast local memory / VMEbus transfers
- VMEbus to local bus interface, and local bus to VMEbus interface
- Two 32-pin flash memory PLCC sockets (1MB 16-bit flash) devices
- Four 16-bit Smart Voltage SMT devices that can be populated with 4Mbit or 8Mbit flash devices
- 8KB NVRAM with Real-Time Clock and battery backup
- Reset and abort switches; four status LEDs
- Watchdog timer, one 16-bit timer in ISA bridge, and four 32-bit timers in MPIC
- Software interrupt handling via PCI-MPU bridge and PCI-ISA bridge controllers
- Two IEEE P1386.1 PMC slots with P2 I/O support for both slots
- Rear I/O via the VME P2 connector
- One asynchronous debug serial port via front panel RJ45 connector
- 10BaseT/100Base TX Ethernet connections via front panel RJ45 connector
|
Please inquire about availability |
|
MPC750 |
|
MPC750 PowerPC 6U VMEbus Processor Modules |
MVME2700 |
- 233 MHz, 266 MHz, or 366 MHZ MPC750 PowerPC processor
- VME64 bus extension
- 16MB to 256MB ECC DRAM
- 1MB on-board L2 cache
- DMA for fast local memory / VMEbus transfers
- VMEbus to local bus interface, and local bus to VMEbus interface
- Two 32-pin 1MB flash memory PLCC sockets, 4MB or 8MB 64-bit flash devices
- Four programmable 32-bit tick timers; watchdog timer
- 8KB NVRAM with Real-Time Clock and battery backup
- Adjustable mapping PCI-MPU bridge controller
- Reset and abort switches; six status LEDs
- Parallel, serial, SCSI and Ethernet I/O via rear transition modules (MVME712 and MVME761 compatible)
- One IEEE P1386.1 PMC slot with P2 I/O support
- Rear VME I/O via the VME P2 connector
- Front panel support for keyboard, mouse and floppy disk drive
|
Please inquire about availability |
|
Emerson Network Power (Motorola) 6U VME 5100 Series PowerPC SBC
(Including standard temperature versions of MVME 5100, 5107 and 5110) |
MVME5100
|
- MPC7410 or MPC750 class microprocessor with 32KB/32KB L1 cache
- Up to 2MB of secondary backside cache
- 100 MHz front-side bus
- Up to 512MB of on-board ECC SDRAM-expandable up to 1GB with optional RAM500 memory expansion
modules
- 17MB Flash memory
- Dual IEEE P1386.1 compatible 32/64-bit PMC expansion slots
- 64-bit PCI expansion mezzanine connector allowing up to four more PMCs
- Dual 16550 compatible async serial ports
- Dual 10BaseT/100BaseTX Ethernet
- 32KB NVRAM and time-of-day clock with replaceable battery backup
- Four 32-bit timers and one watchdog timer
- On-board debug monitor
- Single VME slot even when fully configured with two PMC modules and both add-on memory
mezzanines
- Commercial temperature versions available
- Single Slot
- Optional Transition Module for rear panel I/O
- MVME5100 Series supports booting a variety of operating systems:
- Wind River Sysytems, VxWorks
- Green Hills, Integrity
- Multiple Partners, Linux
|
|
|
MPC755 |
|
Emerson Network Power (Motorola) Extended Temperature 6U VME PowerPC SBC |
MVME5106 |
- Operating temperature range -20°C to +71°C
- 400MHz MPC755 class microprocessor with 32KB/32KB L1 cache
- Up to 2MB of secondary backside cache
- 100 MHz front-side bus
- Up to 512MB of on-board ECC SDRAM-expandable up to 1GB with optional RAM500 memory expansion
modules
- 17MB Flash memory
- Dual IEEE P1386.1 compatible 32/64-bit PMC expansion slots
- 64-bit PCI expansion mezzanine connector allowing up to four more PMCs
- Dual 16550 compatible async serial ports
- Dual 10BaseT/100BaseTX Ethernet
- 32KB NVRAM and time-of-day clock with replaceable battery backup
- Four 32-bit timers and one watchdog timer
- On-board debug monitor
- Single VME slot even when fully configured with two PMC modules and both add-on memory
mezzanines
- Commercial temperature versions available
- Single Slot
- Optional Transition Module for rear panel I/O
- MVME5106 supports booting a variety of operating systems:
- Wind River Sysytems, VxWorks
- Green Hills, Integrity
- Multiple Partners, Linux
|
|
|
MPC7410 |
|
Emerson Network Power (Motorola) 6U VME 5100 Series PowerPC SBC
(Including Commercial Temperature versions MVME 5100, 5107 and 5110) |
MVME5100
|
- MPC7410 or MPC750 class microprocessor with 32KB/32KB L1 cache
- Up to 2MB of secondary backside cache
- 100 MHz front-side bus
- Up to 512MB of on-board ECC SDRAM-expandable up to 1GB with optional RAM500 memory expansion
modules
- 17MB Flash memory
- Dual IEEE P1386.1 compatible 32/64-bit PMC expansion slots
- 64-bit PCI expansion mezzanine connector allowing up to four more PMCs
- Dual 16550 compatible async serial ports
- Dual 10BaseT/100BaseTX Ethernet
- 32KB NVRAM and time-of-day clock with replaceable battery backup
- Four 32-bit timers and one watchdog timer
- On-board debug monitor
- Single VME slot even when fully configured with two PMC modules and both add-on memory
mezzanines
- Commercial temperature versions available
- Single Slot
- Optional Transition Module for rear panel I/O
- MVME5100 Series supports booting a variety of operating systems:
- Wind River Sysytems, VxWorks
- Green Hills, Integrity
- Multiple Partners, Linux
|
|
|
|
|
|
MPC7448 |
|
Conduction cooled MPC7448 VME64x VITA 31.1 Single Board Computer |
5800/5801 |
- MPC7448 1.5 GHz microprocessor (1 GHz in CC) with :
- L1 caches : 32KB Inst. and 32KB Data with parity
- 1MB of L2 integrated cache with ECC
- 512MB or 1 GB of SDRAM-DDR with ECC
- 64MB or 128MB of soldered Mirror Flash
- Up to 1 GB soldered Nand Flash
- 256KB (128-bit wide access) of high speed SRAM
- 32KB of FRAM (non-volatile memory)
- PPC Real Time clock and four 32 bit-timers
- Calendar clock with supercap backup
- Temperature sensor and monitoring
- VME64x with 2eSST (Tsi148)
- Two PMC slots with VITA35 routing : one Pn4 (64 IO) on P2 rows A/C, one partial Pn4 on P0
- Marvell DiscoveryTM III system controller:
- Three Ethernet 10/100/1000TX ports with:
- Support for Jumbo frames
- Virtual Cable Tester on line
- Two routed on rear P0 and one on the front panel
- One serial interface for the front console port
- One USB2 controller with a three ports internal hub
- GPIO on P0
- A four channels SATA controller with two ports on P0 and two ports available
through an on-board planar connector
|
|
|
MPC7455 |
|
Emerson Network Power (formerly Motorola ECC) - 6U VMEbus 1GHz PowerPC SBC |
MVME5500 |
- MPC7455 processor at speeds of 1 GHz and beyond, ideal for data intensive applications
- 256KB of on-chip L2 cache and 2MB of L3 cache
- AltiVec coprocessor for high-performance computational applications
- 40MB Flash memory (32MB soldered and 8MB in sockets)
- Dual PCI buses and dual PMC sites with a bus speed of up to 66 MHz
- One Gigabit Ethernet & One 10/100BaseTX Ethernet interface
- Single VME slot even when configured with up to two mezzanine modules
- Software supported: VxWorks and Linux
- *Now available as a bundle with operating systems, storage, and transition I/O. See our Applipak "Boot and Go"
CPUs. Click here
 for datasheet.
|
|
|
MPC7457 |
|
This was the first Motorola VMEbus SBC designed with the Tundra Tsi148™ VMEbus interface chip
offering 2eSST VMEbus performance. The 2eSST (two edge source synchronous transfer) protocol causes the VMEbus to run at a practical bandwidth of 320MB/s in most cases, thereby giving the bus an 8x performance
increase over VME64's 40MB/s transfer rate.
The MVME6100 series provides more than just faster VMEbus transfer rates; it provides balanced performance from the processor, memory subsystem, local buses and I/O
subsystems. The MVME6100 provides a high performance platform that allows customers to leverage their investment in their VME infrastructure. |
|
2eSST VMEbus MPC7457 PowerPC® Single-Board Computer |
MVME6100
|
- 2eSST VMEbus protocol with 320MB/s transfer rate across the VMEbus
- 1.267 GHz MPC7457 PowerPC® processor
- 128-bit AltiVec™ coprocessor for parallel processing, ideal for data-intensive
applications
- Up to 2GB of on-board DDR ECC memory and 128MB of Flash memory for demanding applications
- Two 33/66/100 MHz PMC-X sites allow addition of industry-standard, application-specific modules
- Dual Gigabit Ethernet interfaces for high performance networking
- VxWorks and Linux board support packages available
- *Now available as a bundle with operating systems, storage, and transition I/O. See our Applipak "Boot and Go"
CPUs. Click here for datasheet.
|
|
|
MPC8240 |
|
Motorola MVME2100 Series VME Processor Modules |
MVME2100 |
- MPC8240 32-bit microprocessor
- L1 cache-16KB/16KB MPC60x class
- 32MB of on-board SDRAM with optional ECC protection
- Two 32-pin PLCC/CLCC sockets for Flash memory; up to 1MB capacity for on-board firmware or
user-specified requirements
- 4MB on-board Flash memory for user-specified requirements
- One IEEE P1386.1 compliant 32-bit PMC slot with front-panel and P2 I/O
- Three 32-bit PCMIP expansion slots, compatible with VITA 29 Draft Standard: one Type I slot
with rear panel I/O and two Type II slots with front panel I/O
- 32-bit PCI expansion mezzanine connector
- Ethernet transceiver interface with 32-bit PCI local bus DMA, 10/100Mb/s with auto-negotiate
speed select
- 8K x 8 NVRAM and time-of-day clock with replaceable battery backup
- Four 32-bit timers, one 16-bit timer, one watchdog timer
- Single Slot
- Optional Transition Module for rear panel I/O
|
Please inquire about availability |
|
MPC8240 |
|
6U VMEbus PowerPC e500 Single Board Computer |
MVME3100 |
- Freescale MPC8540 System-on-Chip processor
- 256MB/512MB DDR ECC SDRAM; 64MB/128MB of Flash memory
- Dual Gigabit, one 10/100 Ethernet ports, USB 2.0 and SATA controllers
- Tsi148 PCI-X bus to VMEbus bridge with 320MB/sec 2eSST VMEbus protocol
- Dual PMC-X sites
- Five serial ports, RTC, four tick timers, watchdog timer, and Rear Transition Module (RTM)
- Board support packages for VxWorks and Linux
|
|
