• Compliant with RoHS 2002/95/EC
• 3.3V or 5V PCI signaling
• Sil3512 chipset supports:
  • SATA/150 MB per second transfer rates
  • 33/66 MHz PCI operation
  • 48-bit sector addressing
  • Compliant with PCI 2.3
• Can be used on any Single Board Computer with an industry standard IEEE P1386.1 PMC site
• Uses a 9.5 mm high 2½” SATA hard disk or SATA solid state Flash disk
• Rotating drives available in standard, enhanced duty, and rugged extended temperature versions
• Flash disks from 8 to 64GB; consult ACT regarding qualified flash drive configurations and highest available capacity before ordering
• Consult ACT for extended temperature solutions up to -40° to + 85°C
• Green LED indicator for drive activity monitoring
• Available with conformal coating
• Supports several operating systems including VxWorks, Linux, and Windows

• Compliant with the Restriction of Hazardous Substances Directive (RoHS) 2002/95/EC
• PCI680 chipset supports UDMA-6 ATA/133 MB
  per second transfer rates
• Can be used on any Single Board Computer with an industry standard IEEE P1386.1 PMC site
• Uses a 9.5 mm high 2½” ATA/IDE hard disk or solid state 2½" IDE Flash disk
• Rotating drives available in standard, enhanced duty, and rugged extended temperature versions
• Flash disks from 8 to 32GB; consult ACT regarding qualified flash drive configurations and highest available capacity before ordering
• Consult ACT for extended temperature solutions up to -40° to + 85°C
• Available with conformal coating
• 3.3V or 5V PCI signaling
• Supports several operating systems including VxWorks, Linux, Solaris and Windows

Download Datasheet

PMCDisk - Rotating or Solid State Flash disks
Models 9260-Solid State/9260-Rotating

NOTE: This product is not recommended for new designs. Please refer to the 9261G or 9262G PMCDisks above.

• Standard PMC form factor (IEEE P1386.1)
• Can be used on any SBC with a PMC slot
• ATAPI/ATA-6 compliant mass storage solution
• Uses a 9.5 mm high 2½" ATA/IDE hard disk or solid state 2½" IDE Flash disk
• Rotating drives available in standard, enhanced duty, and rugged extended temperature versions
• Flash disks from 8 to 32GB; consult ACT regarding qualified flash drive configurations and highest available capacity before ordering
• 3.3 V power not required; 5V tolerant signaling
• Boot and run most OS including Linux, Solaris, VxWorks and Windows
• Open Boot Module supported to allow the PMCDisk to boot on any PCI-compliant SPARC platform
• ATA disks available in Enhanced Duty cycle versions for NEBS Level 3 - 7/24 requirements

Download Datasheet

Flash PMCStor - NAND Solid State Flash PMCStor
Model 9280

• Designed to withstand harsh temperature, shock & vibration environments
• NAND arranged in array of 4 Flash banks
• Three high-speed USB ports, one on the front panel and two ports via the rear PN4 I/O connector allow for additional memory access options
• Low power consumption of 5W or less
• Supports wear leveling and write protect, error detection and bad block correction
• Can be seen as individual drives or a single drive in RAID mode
• Offers security features such as write protection
• Extended operating temperature range (-40°C to +85°C)
• USB Flash disk controller ver. 1.0
• Uses industrial temperature range components (-40°C to +85°C degrees operating)
• With bootable device drivers for Linux, VxWorks, and Windows, the Flash PMCStor is an ideal embedded storage solution for rugged applications
• Available with optional conformal coating per MIL-I-46058C

Available soon -- please contact ACT/Technico sales for more details.

• Compliant with Restrictions of Hazardous Substances (RoHS) 2002/96/EC
• Designed to support one or two rugged CompactFlash drives (CFI or CFII) allowing  for enhanced environmental performance in your application. MTTR is significantly reduced by using sockets that allow easy removal while clamps hold the drives in place during normal operation
• ATAPI/ATA-6 compliant mass storage solution implemented on industry standard PMC form factor (IEEE P1386.1)
• An alternative to Narrow SCSI based mass storage, where SCSI capacities exceed the needs of most embedded applications
• Replaces external hard drives or Disk Modules that require external fixtures or system slots
• SiI0680 chipset supports Ultra ATA / 133 MB per second transfer rates (UDMA 6)
• 40- or 44-pin connector brings standard ATA/IDE DMA interface out the front for external drives

Download Datasheet

PMCStor
Models 9255/9256/9257/9259

NOTE: This product is not available for new designs. Please refer to the 9275 series PMCStor above.

With bootable device drivers for Linux, VxWorks, Windows, the PMCStor is an ideal embedded storage solution

• Removable storage
• Standard PCI Mezzanine (PMC) form factor
• Complete solution, with drive(s), interface, and software driver provided
• High quality, optimized multilayer design
• 40- or 44-pin connector brings standard ATA/IDE interface out the front
• Option to bring interface out the rear of PMC
• Up to 2 GB with two IBM Microdrives® or up to 320 MB with two CF-II Drives
• Sockets are CF-II form factor
• Five versions available - see specifications for details

Download Datasheet

• Complete solution, with drive, interface, and software provided
• Replaces external hard drives or Disk Modules that require external fixtures or system slots
• Eliminates cables and the need to use SCSI based storage solutions
• Ultra ATA/133 mass storage solution on PMC form factor
• Uses industrial temperature range components (-40°C to +85°C degrees operating)
• 32-Kbyte Flash memory provides storage for BIOS
• Supports CompactFlash drives (CF and CF-II) allowing for enhanced environmental performance.
• Each complete unit undergoes functional testing before, during, and after a 10-cycle environmental stress screen (ESS) to confirm reliable operation of the complete solution
• Available in two versions:
• Convection cooled extended temp with solid front panel
• Conduction cooled extended temp with no front panel
• Available optionally with conformal coating when required

Download Datasheet